TRF3765EVM: TRF3765EVM Schematic : +5.0V Connection

BH KIM

Prodigy 145 points

Part Number: TRF3765EVM

I bought TRF3765EVM REV E.

I think +5.0V Connection to Regulators is not connected. I tested the connection is open.

Is there any other problem if I connect 5V of USB output to + 5.0v?

over 5 years ago

0 Noel Fung over 5 years ago

TI__Guru* 88960 points

Hi BH,

To use these regulated 3.3-V supplies, disconnect power from TP2 and remove R41. Connect 5 V to TP26, using TP27 for ground. Place jumpers on JP4 and JP5 to shunt jumper pins 1 and 2.

If you use the 5V from a USB device, make sure it is capable of supplying 250 mA.

0 BH KIM over 5 years ago in reply to Noel Fung

Prodigy 145 points

Thank you, Fung.

I should have read the datasheet 2.2.

Default Power Supply mode is the EVM board uses external power supply connected 3.3V TP.

Regards, Fung

Clock & timing

Clock & timing forum

TRF3765EVM: TRF3765EVM Schematic : +5.0V Connection