LMK04616: Control LMK04616 device through USB2ANY and TICS Pro

Cedric Labrosse

Part Number: LMK04616
Other Parts Discussed in Thread: USB2ANY

Hi,

Is it possible to configure an LMK04616 device implemented on a custom board (not an EVM) through USB2ANY dongle and TICS Pro software ?

Thanks in advance for your help.

over 4 years ago

0 Derek Payne over 4 years ago

TI__Mastermind 28960 points

Hi Cedric,

Yes, it is possible. The most straightforward method is copying the USB2ANY header pinout and connections directly from the EVM onto your new design. If the GPIO pin control features like pin SYNC or RESET are not needed, the header connections could also be reduced to just the SPI lines.

Regards,

0 Cedric Labrosse over 4 years ago in reply to Derek Payne

Prodigy 20 points

Hi Derek,

Thank you for your reply.

Regards,

Cédric Labrosse

Clock & timing

Clock & timing forum

LMK04616: Control LMK04616 device through USB2ANY and TICS Pro