Other Parts Discussed in Thread: DPS-DONGLE-EVM, , TICSPRO-SW, USB2ANY
Hello, I would like to know if I can use DPS-DONGLE-EVM board to configure SPI interface of LMX2595EVM boar.
I have seen that it's possible to connect as follow :
MOSI --> SDI
CLK --> SCK
GND --> GND
SS --> CSB
Other pins on LMX2595EVM should be left open. But Is software TICSPRO-SW will recognize DPS-DONGLE-BOARD and allow to configurate LMX2595EVM ?
Per advance thank you
Best regards