Dear team,
Following is the configuration requirement from my customer:
1.there are 3 ramps in one chirp, ramp1:1500M-1505M, 15us, ramp2:1505M-1500M, 19us, ramp3: 1500M CW, 5us
2. Ramp is triggered by MOD pin
2. Ramp1 trigger a flag to TRIG1 pin
4. ramp should stop after 10 chirps until MOD is toggle again
Please check the following config, the first three requirements (1&2&3) are achieved but the ramp can't stop after MOD pin toggling. However, there are few materials for ramp count, I think there must be some mistake in my config. Can you provide some suggestions?
B&R
Lijia