Dear Specialists,
My customer is evaluating DAC53608EVM and has a question.
I would be grateful if you could advise.
---
We are confirming DAC53608EVM by connecting our original control board.
LDAC=-(non synchronous mode)
If it was set to power down mode in DEVICE_CONFIG
DACx_DATA could not be set.
After rewriting DEVICE_CONFIG from the initial value 0xFF to 0x00
When I rewrote it to DACx_DATA, the voltage could be output.
Are these behaviors correct in the device specifications?
---
I appreciate your great help in advance.
Best regards,
Shinichi