AFE49I30: Sampling signal from multiple PD during Window #M within the Active Phase of PRF

Santosh Kumar

Part Number: AFE49I30

Hi support team,

Is it possible to receive separate output corresponding to each PD in a window( Window #M within the Active Phase of PRF) and thus create a AC signal for two different PD?

Thanks.

over 2 years ago

0 Praveen Aroul over 2 years ago

TI__Mastermind 49176 points

Hello Santosh,

We would like to take this discussion offline since the device AFE49I30 is shared under selective disclosure.

Can you please reach out to biosensing_afe-support@list.ti.com along with a reference to this E2E post?

When you send the email to the mailing list, can you please elaborate on your question?

0 Santosh Kumar over 2 years ago in reply to Praveen Aroul

Prodigy 50 points

Hi Praveen,

Thank you. I have sent my query 4 days ago to biosensing_afe-support@list.ti.com.

Now awaiting the response.

0 Praveen Aroul over 2 years ago in reply to Santosh Kumar

TI__Mastermind 49176 points

Hello Santhosh,

Apologize for the delay in our response. We shall get back to you via email by tomorrow.

0 Praveen Aroul over 2 years ago in reply to Praveen Aroul

TI__Mastermind 49176 points

Hello Santhosh,

I will close this e2e post since I have responded to your question via email. For any follow up questions, we can discuss through email.

Data converters

Data converters forum

AFE49I30: Sampling signal from multiple PD during Window #M within the Active Phase of PRF