Request you to help us in the following queries:
Firstly thank you very much for the support as we could able to program the ic and get data from a single channel(AIN0,AIN1 sensor connected).
question1:I AM PROGRAMMING THE IC from FPGA.
1.Continous conversion mode
3.PGA 32 GAIN
4.LOW LATENCY FILTER
how to program the ic for getting the data from remaining 5 channels as we are using differential inputs. can you help us in flow for acquiring the data for remaining 5 channels.
For acquiring the single channel data i am using following flow:
1.write the data to configuration registers. I am using first five registers. while writing to registers sart/sync is high
2.making start/sync pin low ,waiting for 24 t clk cycles
3..start/sync high, waiting for 28 t clk cycles
4.start/sync low, checking for DRDY to be low
7.going back to 1.
a)when to send the calibration commands. Is there any particular sequence to send the calibration commands.?
b)how to send the calibration commands for all channels?