This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS7952: Wait after changing channel sequence mode

Genius 14040 points
Part Number: ADS7952

Hello,

 

Our customer has a question for ADS7952.

When changing the channel sequence mode, for example from default Manual mode to Auto-2 mode, is a certain wait required before sending the next command?

Or is it OK to send the next command immediately after the change?

 

Regards,

Oba

  • Hi Oba-san,

    There are various flow charts in the datasheet that describe going into one of the auto sequence modes of the ADS7952.  Not sure what 'next command' you might be referring to, but there is no specific wait period needed between commands.  Is there a particular scenario that you would like to highlight here?

  • Hello Tom.

    Sorry "command" may not be good expression.
    After changing the mode to Auto-2 mode at N frame, they want to send next N+1 frame to start conversion immedeatly.

    I understand any wait is not required.

    Regards,
    Oba