• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 45 subscribers
  • Views 212 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS8578S: Reading in parallel interface mode

Shikhar Meshram
Prodigy 10 points
Part Number: ADS8578S

Dear sir,

Request you to help me with following queries:

I am programming ADS8578S with 14 bit 8 channel ADC with TMS320F28235PGFA DSP.

I am trying to read data in parallel interface mode.

For this I have made PAR/SER/BYTE SEL pin low for selecting parallel interface.

I have kept CS and RD pin separate and giving both the signals from DSP.

CONVSTA and CONVSTB are tied together and I am giving the CONVST signal from DSP.

While I am reading from different channels,

I am able to read only from channel 1 and all other channels are getting same value.

But while reading from channel 2 - 7, I am not able to see any data.

I have given one unused address of DSP for external ADC of length 1.

Request you to help me with this.

Also for any other information required please reply.

  • 0
    TI__Mastermind 39755 points

    Hi Shikhar,

    Thanks for choosing ADS8578S in your design. Can you please provide a timing plot with /CONVST,BUSY,/CS and /RD captured with an oscilloscope? Is the data for channel 0 correct for input signal? Your schematic will be very helpful.

    Thanks&regards,

    Dale