• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 46 subscribers
  • Views 123 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADC12DJ5200RFEVM: part identification and ADC memory map

Alen Barisic
Intellectual 1300 points
Part Number: ADC12DJ5200RFEVM

Hi Team,

  1. We need to make use of the onboard clock facilities. Section 7.2.2 in the user  manual well describes the required board modification steps. However, it’s a bit tricky to identify the components on the board. Please check the picture below and confirm that we have identified the components correctly.
  2. Does the ADC configuration GUI provides the final memory map which has to be loaded on the ADC chip? Is this software open source or are there any C library or dll which accelerate SW development?

Thanks a lot!

Best regards,

Alen

  • +1
    TI__Mastermind 20541 points

    Hi Alen,

    I don't think the picture is attached to the last post. Anyhow here is screenshot showing the modes. 

    Yes, you can double click the bottom left side of the GUI where it say Idle and the log window will open which will record all the register writes when any button is clicked on the gui. 

    Regards,
    Neeraj