ADS42JB69EVM: Queries and clarifications

ArTzy

Part Number: ADS42JB69EVM

Hi Experts,

Good day. Seeking advise on this queries about the Analog-to-Digital Converter (ADC) ADS42JB69EVM, that are not clear on the documentation:

1. The ADS42JB69EVM board is compatible with the TSW14J10EVM and Xilinx Zynq ZC706 setup? What are the steps to operate this setup?
2. The FMC (FPGA Mezzanine Card) on the ADS42JB69EVM board is a LPC (low-pin count) or HPC (high-pin count)?
3. There is some open-source code for the Xilinx Zynq ZC706 to operate with the ADS42JB69EVM board?
4. What is the ADS42JB69EVM minimum analog input bandwidth?

Thank you.

Regards,
Archie A.

over 1 year ago

0 Rob Reeder over 1 year ago

TI__Mastermind 20130 points

Hi Archie,

Might be best to start here and put in a JESD IP request at the link below.

https://www.ti.com/tool/TI-JESD204-IP?keyMatch=JESD%20IP#downloads

This will help jump start the interface with the ADS42JB69EVM and ZC706 interface.

Regards,

Rob

0 ArTzy over 1 year ago in reply to Rob Reeder

TI__Genius 13979 points

Hello Rob,

Thanks for your guidance.

Also, can you please provide answers to the four queries posted?

Thank you very much.

Regards,
Archie A.

0 jim s over 1 year ago in reply to ArTzy

TI__Guru* 91947 points

Archie,

For #1: See attached document.

For #2: The board is designed to use the HPC on the FPGA platforms.

For #3: You can use the source code that can be found under the TSW14J10EVM product folder (older Xilinx code that is not recommended) or request the TI IP that Rob mentioned in the previous post.

For #4: The on-board transformers have a usable bandwidth from 200KHz to 450MHz. The ADC does support input IF frequencies down to DC.

Regards,

Jim

ZC706 ADS42JB69 421 Setup.pptx ZC706 ADS42JB69 222 Setup.pptx 6835.SLAU580B.pdf

Data converters

Data converters forum

ADS42JB69EVM: Queries and clarifications