• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 46 subscribers
  • Views 267 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS127L11: Control custom ADS127L11 board using PHI Controller

Joe Leonard
Prodigy 40 points
Part Number: ADS127L11

Hello, 

I am looking at using the PHI Controller and GUI to control a custom board containing the ADS127L11.

Is it compatible with 4-wire SPI mode or does it need to be connected to the RESET, START and DRDY pins? 

Regards,

Joe 

  • 0
    TI__Guru 62826 points

    Hello Joe,

    I would suggest making all the same connections from your board to the PHI controller as what is shown on the EVM. During the GUI's start-up routine, START or RESET pins may be used to ensure proper initialization after power-up. The DRDYn pin is certainly used in the FPGA data capture patterns.

    Regards,

    Ryan