I have a doubt regarding the procedure mentioned in the datasheet of DAC81416RHA to access DAC through SPI. I am using Labview code.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I have a doubt regarding the procedure mentioned in the datasheet of DAC81416RHA to access DAC through SPI. I am using Labview code.
Hi Paul,
I have confirmed the communication with logic analyser, it's working fine. Can u some provide details regarding configuring the registers mentioned in the datasheet?. I am not getting required output voltage at pins of IC.
Hi Paul,
I have confirmed the communication with logic analyser, it's working fine. Can u some provide details regarding configuring the registers mentioned in the datasheet?. I am not getting required output voltage at pins of IC.
Can you share your schematic?
Start by writing 0x0000 to the GENCONFIG register. This will enable the reference. You can externally measure the reference pin to confirm that you successfully wrote to it.