ADS8365: EOC is not output.

yukihiro nomura

Part Number: ADS8365

If HOLDA, HOLDB, and HOLDC are all low for one clock cycle at the same time, will EOC output three pulses?
Is there a case where EOC is not output even if a pulse is input to HOLD?

over 3 years ago

0 Dale Li over 3 years ago

TI__Mastermind 45955 points

Hi yukihiro,

You should be able to see these low pulses on /EOC. Can you provide a little more detail? If you could perhaps share your schematic around the ADC and maybe a scope trace of your control signals, it will be easy to address potential source of the problems you are facing.

Thanks&regards,

Dale

0 Dale Li over 2 years ago in reply to Dale Li

TI__Mastermind 45955 points

Hi yukihiro,

I have not heard back from you for three weeks, so this thread will be closed. If you still have a question, you can post a new query on E2E forum.

Thanks&regards,

Dale

Data converters

Data converters forum

ADS8365: EOC is not output.