DAC81416: Not Available to Set individual DAC Range Channel. only am Available to Set one Channel from Every Single DAC Range.

Aman Gond

Part Number: DAC81416

Hello Folks,

1.I am Working on DAC81416HRAT Device on which am Available to Set DAC Range for Every Channel Together but am not Available to Set Every Single Channel of DAC on Different Voltage.

Each DAC Range Consist of 4 Channel From that only one Channel of each DAC am Available to Set.

How i Can Set All Channel of on Individual Voltage.?

2.Am Available to Set DAC Value in DAC Data Reg but am Not Available to Read Back that Value.How i Can Read DAC Data Reg Value.

3.What is Proper Sequence for Writing all DAC Reg?

over 2 years ago

0 Akhilesh K over 2 years ago

TI__Mastermind 19086 points

Hi,

Send me the DAC configuration you are using. I mean the register writes you are doing after power up.

Regards,

0 Katlynne Jones over 2 years ago in reply to Akhilesh K

TI__Mastermind 39093 points

Hi Amond,

This is a duplicate thread of:

https://e2e.ti.com/support/data-converters-group/data-converters/f/data-converters-forum/1199480/dac81416-am-not-available-to-set-the-individual-voltage-of-every-dac-channel

It looks like Akhilesh has also requested the DAC configuration you are using (registers and register values) in that thread, so please respond with that there. I am going to close this thread.

Best,

Katlynne Jones

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Data converters

Data converters forum

DAC81416: Not Available to Set individual DAC Range Channel. only am Available to Set one Channel from Every Single DAC Range.