ADS1219: ADS1219_Addressing problem

Aswin Kumar

Part Number: ADS1219

Hi,

We are using ADS1219 in our project. The device does not give output when the address of the ADC is changed. I am getting the output when the address is 0X40, but not when the address is 0X41 (or any other address

). Can you tell me what the problem will be?

over 3 years ago

+1 Bob Benjamin over 3 years ago

TI__Guru** 113765 points

Hi Aswin,

Have you verified that the address of the ADC is set properly as per datasheet table?

It is easy sometimes to misdirect the A0 and A1 address pins. Have you verified the voltage at the device pins? If you are still seeing issues, can you send me your schematic?

Best regards,

Bob B

+1 Aswin Kumar over 3 years ago in reply to Bob Benjamin

Prodigy 80 points

Hi Bob,

The issue has been solved. Thanks for the support.

Addressing are properly done. The problem was with the micro controller we used.After changing the controller, the problem was solved.

Data converters

Data converters forum

ADS1219: ADS1219_Addressing problem