ADS131M04EVM: GUI problem

Brian Wang0928

Genius 14360 points

Part Number: ADS131M04EVM
Other Parts Discussed in Thread: ADS131B04-Q1EVM, ADS131M04

Hello team,

Customer is trying to run the GUI of ADS131B4EVM and following the table 8 for default settings. But it was fail.

Here are some messages . Please help to check what was missing or any comments. thanks.

PSI Error:

USB Device List:

Application: Current Measurements for Battery system

Regards

Brian

over 2 years ago

0 Dale Li over 2 years ago

TI__Mastermind 46135 points

Hi Brian,

You mentioned ADS131M04 ADC part number in the title of this post, however the customer is using ADS131B04-Q1EVM GUI software, can you double check which EVM hardware and what the GUI software the customer is using?

Regards,

Dale

0 Brian Wang0928 over 2 years ago in reply to Dale Li

TI__Genius 14360 points

sorry it was typo. correct one is ADS131B04EVM.

0 Dale Li over 2 years ago in reply to Brian Wang0928

TI__Mastermind 46135 points

Hi Brian,

The first screen shows the EEPROM content on the EVM is not the expected information. The second screen shows that your hardware was not connected and also asked for installing PSI that is part of the GUI. Are the EVM PDK including the EVM board and PHI controller card new? Can you ask the customer to uninstall the GUI software, download it from the website and install it again?

Thanks&regards,

Dale

Data converters

Data converters forum

ADS131M04EVM: GUI problem