• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 46 subscribers
  • Views 133 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADC12D1620QML-SP: How to check the mountings on CGA

Yohei Kusachi
Prodigy 110 points
Part Number: ADC12D1620QML-SP

To Whom It May Concern,

Hope you're well.

Please allow me to submit the question from customer as attached and we'll be grateful if you could kindly provide your knowledge.

TI_Question about ADC12D1620QML-SP_231002.pptx

Thank you for your attention and kind support.

Kind Regards,

Yohei Kusachi

Fuji Electronics America, Inc.

  • +1
    TI__Expert 3360 points

    Hi Kuscahi-san,

    You would need to work with your assembly contractor to determine their capabilities.  However, most of the time it is done with an x-ray to verify that the device has been soldered properly.

    Regards,

    Geoff

  • 0 in reply to Geoff Roth
    Prodigy 110 points

    Hello Geoff-san,

    Thank you so much for your kind reply.

    The assembly contractor's capability is the key and most of the time, x-ray is good way to check if the part is soldered properly, noted.

    Thank you so much again for your knowledge and kind support.

    Please have a great rest of your day.

    Kind Regards,
    Yohei Kusachi