Original question:
ADS1261EVM: The device does not switch back from device firmware update mode to the bulk mode
My ads1235evm was working.
Now, when I run DS Eval program, the 1235 registers don't appear.
the console seems to indicate the ads1235 is there..
and Device Manager shows the board...
I tried reprogramming the evm and it reported success, but no change in behavior...
Is there anything else to try?
mark
Hi Mark,
Apparently the GUI cannot find the device package that should be residing in DSEvalSW folder under the user Documents main folder. Is this the location of your files? Also the location in the main gui should match the location of your actual files. Check under Files-> Options menu.
Best regards,
Bob B
