• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 47 subscribers
  • Views 125 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

AMC60704: AMC60704

Zhixiong Liu
Prodigy 10 points
Part Number: AMC60704

Tool/software:

Screenshot as above, issues encountered in debug:

1. VCC_MCU=3.3VDC, VCC_5V=5VDC, VCC_LASER=1.55VDC, are there any power supply sequence and timing requirements for these power supplies?

2. When IDAC/VDAC/ADC is not normally external load or input in PCBA debug, VDAC cannot test the normal set voltage. The current  VDAC measured voltage is 0VDC, and I2C cannot read the normal value after the ADC get voltage.

Emergency help, thanks

  • 0
    TI__Guru 53573 points

    Hi Zhixiong,

    1. There is no required supply sequence.

    2. Can you confirm you are able to read or write to the device? For example, can you successfully read the CHIP_ID register (0x02)?  We should confirm communication is valid first.  Are you using the register paging system correctly?

    Thanks,

    Paul

  • 0 in reply to Paul_Frost
    Prodigy 10 points

    Hi Paul,

    Thanks for your reply.

    At present, there is no error in I2C communication and we will double check I2C waveform and timingSince lack of the load for IDAC and VDCA Pin in PCBA debug， is the successful setting of IDAC current and VDAC voltage affected?

  • 0 in reply to Zhixiong Liu
    TI__Mastermind 34058 points

    Hi Zhixiong,

    Do you see either a IDAC current of VDAC voltage at any of the outputs? Are you making sure to power these outputs on in the power enable register? 

    Best,

    Katlynne Jones