ADS1100: ADS1100A0IDBVR

AJAY S

Prodigy 90 points

Part Number: ADS1100
Other Parts Discussed in Thread: ADS1115

Tool/software:

Hi Ti Team,

Am Happy to assist you!

I'm looking for electrical specification for the part number below

ADS1100A0IDBVR ,Description:16-Bit, 128SPS, 1-Ch Delta-Sigma

Thermal resistance JA (C/W)?

Regards,

Ajay S

3 months ago

0 Angel Rodriguez de San Miguel Bermudez 3 months ago

TI__Expert 7240 points

Hi Ajay,

AJAY S said:
I'm looking for electrical specification for the part number below

This can be found in page 3 of the ADS1100 data sheet: ADS1100: Self-Calibrating, 16-Bit Analog-to-Digital Converter datasheet (Rev. B)

AJAY S said:
Thermal resistance JA (C/W)

We don't have this information to share for this device, only what is stated in the data sheet is available.

The ADS1100 is an older device, for new designs we recommend taking a look at the ADS1115 family of devices, as they are newer devices with the same functionality and increased performance.

ADS1115 data sheet, product information and support | TI.com

ADS1114 data sheet, product information and support | TI.com

ADS1113 data sheet, product information and support | TI.com

Best Regards,

Angel

0 AJAY S 3 months ago in reply to Angel Rodriguez de San Miguel Bermudez

Prodigy 90 points

Hi Angel,

Thanks for prompt reply,

As per your suggestion I am using ADS1114IRUGT One channel is enough for me.

Analog Input [0-5V]

ALERT/READY function. we are not going to use with FPGA.I just pulled up with 5V By 10K Is that fine?

0 Angel Rodriguez de San Miguel Bermudez 3 months ago in reply to AJAY S

TI__Expert 7240 points

Hi Ajay,

AJAY S said:
I just pulled up with 5V By 10K Is that fine?

Yes that is fine. If unused, the ALERT/RDY pin can be left floating, or you can tie the pin to VDD with a pull up resistor. From the data sheet:

Best Regards,

Angel

Data converters

Data converters forum

ADS1100: ADS1100A0IDBVR