ADS8528: Parallel Read Access

user5093781

Intellectual 375 points

Part Number: ADS8528
Other Parts Discussed in Thread: ADS8568

Tool/software:

Hi.

We are planning to use parallel read.

If the RD signal is output earlier than the CS signal, Does ADS8528 out data?

Best regards.

4 months ago

+1 Tom Hendrick 4 months ago

TI__Guru**** 176551 points

Hi there 5093781!

In most situations, the /RD signal associated with the parallel data bus is what strobes the actual conversion results into the host processor. If /CS is high, the ADS8568 outputs will be in tri-state so any strobing of /RD will not provide the proper conversion results to the controller. You have to set /CS low first before strobing the /RD pin.

0 user5093781 4 months ago in reply to Tom Hendrick

Intellectual 375 points

Thanks Tom.

Data converters

Data converters forum

ADS8528: Parallel Read Access