• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 47 subscribers
  • Views 540 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS1259EVM-PDK problem

Mark Yaroslavski
Prodigy 30 points

Other Parts Discussed in Thread: ADCPRO, ADS1259EVM-PDK, ADS1259

I have installed the latest software and drivers (from ti site). Following the "Error 85" problem fixed by replacing "adcpro_evm.ini" file an error with code 6004 "libmmb0.lvlib:check_styx_err.vi<ERR> usb receive error / ads1259evm/ads1259dr" has appeared.

Please advise how to proceed.

BR,

Mark.

  • 0
    TI__Guru**** 182601 points

    Hi Mark,

    Welcome to our forum!  The first error you encountered is due (I believe) to an EEPROM programming issues on the ADS1259 evaluation module.  We're looking into that now.  The new error code you see may be related to how you have the ADS1259EVM-PDK powered.  Have you applied the +/-VA (+/-10 to +/-15V) supplies to either J11 on the ADS1259EVM or J14 on the MMB0?

  • 0
    Prodigy 30 points

    Hi, Tom!

    You are correct. I tried to operate the board from +/- 5V only, when +5V is connected to +VA and to +5V via jumpers (J13A and J13B) on MMB0. This connection is legal but a power supply has reached current limit point during the initialization. I hope this is the only cause to the error. Following the +5V current limit had increased it started to work.

    Thank you for prompt reply.

    BR,

    Mark.