I applied following configuration to ads8327 but i didn't get EOC signal. its remains at high;
VA=3.3V, Vref(+)=2.5V, vref(-)=0v(gnd), vin(uni-polar)=0 to 2.5v
i tied sdi pin to 3.3v to use adc in default mode(and read while converting). i applied convst signal(low for 80ns and high for 2.1us) and applied cs_bar signal(and sclk) after 40ns from falling edge of convst signal continuously. frequency of sclk is 25Mhz.
my problem is i'm not getting the conversion signal. i always remains at high. i not able to find out what is wrong ?
it is problem with IC or configuration or what ?
