• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 46 subscribers
  • Views 186 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS62C17's power supply deploy

Donald WU
Prodigy 160 points
Other Parts Discussed in Thread: ADS62C17

Hi, everyone;

We have a PCB which has three ADS62C17 ADC and some other analog and digital IC on it.

My question is: to achieve the best ENOB performance, do we need deploy one LDO for each ADS62C17? On the base of ENOB, which power supply is most important. AVDD or DVDD? How to estimate the influence of voltage ripple on the ENOB, or spur interference?

 

THX!

 

Donald

  • 0
    TI__Genius 17290 points

    Hi Donald,

    The AVDD supply is the analog supply for the chip and the DRVDD is the digital supply. The analog supply is the critical supply for noise performance and should be separate from the digital supply for best results. Since the digital supplies shouldn't effect the analog performance so you could likely use a single LDO to cover DRVDD for all three chips (assuming current requirements are met). It is possible that you could use a single LDO for the AVDD supplies for all three chips as well. If you need good isolation between chips, three separate LDOs may be safer.

    To estimate the effect of voltage ripple on ENOB, you would need to measure the PSRR of the part for the frequencies of interest. Based on the measured voltage ripple (powers of the harmonics), you can then estimate the spur level at the ADC output due to the power supply ripple.

    Regards,
    Matt Guibord 

  • 0 in reply to Matt Guibord
    Prodigy 160 points

    Hi, Matt;

    Thanks! You are very helpful!

     

    Donald