ADC10D1500RB Design Package (snac038) seems be not complete!

Tony Chopper

Other Parts Discussed in Thread: ADC12D1600RB

Hello,everyone! I need your help! I download the ADC10D1500RB Design Package(snac038). But when I open the project in ISE. Some files are missing. Thank you!

The files below the path "\snac038\ADC10D1x00RB Design Package\FPGA Source Code\coregen" are as follows:

I cannot find the missing files! Thank you for the help!

over 7 years ago

0 Jim Brinkhurst1 over 7 years ago

TI__Mastermind 43870 points

Hi Tony

I'm trying to locate the missing files, or the module/primitives needed to regenerate them.

I hope to have them tracked down by Monday.

Best regards,

Jim B

0 Tony Chopper over 7 years ago in reply to Jim Brinkhurst1

Intellectual 270 points

Thanks a lot!

0 Tony Chopper over 7 years ago in reply to Jim Brinkhurst1

Intellectual 270 points

Hello, Jim. It is still unchanged.

0 Jim Brinkhurst1 over 7 years ago in reply to Tony Chopper

TI__Mastermind 43870 points

Hi Tony

I have not been successful locating those missing files for the ADC10D1500RB design.

I have located similar files for the 12 bit ADC12D1600RB design. The FIFO widths are in 12 bit multiples instead of 10 bit multiples, otherwise the naming is similar.

If those would be useful I can send them.

Best regards,

Jim B

0 Tony Chopper over 7 years ago in reply to Jim Brinkhurst1

Intellectual 270 points

Thank you, I do not need them for the moment. Thanks a lot!

Data converters

Data converters forum

ADC10D1500RB Design Package (snac038) seems be not complete!