This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Reset for ADS1211

Other Parts Discussed in Thread: ADS1211

Dear Technical Support Team

I have a question about ADS1211.

Is it better to issue reset sequence of "FIGURE 27. Resetting the ADS1210/11" every power up?

Datasheet shows " If the power supply ramp rate is greater than 50mV/ms, this circuit will be adequate to ensure that the device powers up correctly."

                             "If this requirement cannot be met or if the circuit has brown-out considerations, the timing diagram of Figure 27 can be used to reset the ADS1210/11. "

So I think that it is better to issue reset sequence if requirement is satisfied or not.

Best Regards,


  • Hi Y.I.,

    It is ok to use the RESET pattern after every power up to ensure proper operation.  If you use the RESET pattern, make sure you wait a minimum of 25ms after the supply is stable before sending the pattern.

    Best regards,

    Bob B