• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 47 subscribers
  • Views 596 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DAC128S085: IF DAC DOUT signal is tri-state, can this parts be used on SPI bus with other SPI devices

Yury Milgram
Prodigy 100 points
Part Number: DAC128S085

IF DAC DOUT signal is tri-state, can this parts be used on SPI bus with other SPI devices or does it need try-stated buffer on DOUT signal

Thank you,

  • 0
    TI__Mastermind 46290 points

    Yury,

    Based on the comment on page 17 of the datasheet in the second to last paragraph, I believe the DOUT is idle low when SYNC is high, however I would agree that the datasheet does not indicate whether it is driven low or high-z.

    We will need to dig into this a bit deeper and get back to you.

    We will strive to get you an update by the end of the week.

  • 0 in reply to Kevin Duke
    TI__Genius 14220 points
    Hi Yury,

    Thank you for reching out. We are very sorry for not being very specific in the datasheet regarding the DOUT state. I measured it physically and saw that the DOUT is pulled down to ground with a 1k Ohm internal resistor. So, it's not an ideal high-z condition. But you can design your circuit keeping this resistance value in mind.

    Regards,
    Uttam Sahu
    Applications Engineer, Precision DACs
  • 0 in reply to Uttam Sahu
    Prodigy 100 points

    Thank you,