• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 46 subscribers
  • Views 304 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TLC7524: Bipolar Operation Mode & Reading the output

Austin Brummett
Prodigy 20 points
Part Number: TLC7524
Other Parts Discussed in Thread: LM358

Hello!

I am using the TLC7524 to generate a sine wave for my senior project. I have been having issues getting bipolar mode operating. I am using a Vref of 2.5V and the output amplifier is a LM358 dual operational amplifier. Also which output do I connect to the oscilloscope because some people look at the output on both pins and other just reference the final output and ground.

Thanks !

  • 0
    TI__Mastermind 46290 points
    Hello Austin,

    Can you please share a schematic for your design?

    You may make measurements anywhere you would like. The output of the first amplifier connected to OUT1 and OUT2 should be a negative voltage spanning from 0V to -2.5V. Depending on your gain settings for the second stage you'll see your bipolar output there.

    While you're making these measurements, I would also verify the reference voltage.
  • 0 in reply to Kevin Duke
    TI__Mastermind 46290 points
    Hi Austin,

    Were you able to make any progress on this?
  • 0 in reply to Kevin Duke
    Prodigy 20 points

    Hey,

    Yes I was. I found that I didn't need bipolar operation for my system, but now I'm in a small pickle because my output is not coming out as I would like. I am trying to create a sine wave from 0-5 V and it is coming out, but the sinusoid is lopsided. The upper half stays up longer than the lower half. I am thinking of adding a capacitor to the end of my opamp output to ground to see if maybe it is a DC issue

  • 0 in reply to Austin Brummett
    TI__Mastermind 46290 points
    Hello Austin,

    I guess let us know the outcome of your upcoming tests. Once again, though, if we are to provide any deeper support it will be helpful to see the schematic and a capture of the actual output behavior.