DAC7311: Output rail issue

user5163865

Part Number: DAC7311
Other Parts Discussed in Thread: OPA277

Hi,

Our customer evaluated the DAC7311, but the output rail was Vs-0.6V. The circuit and data are below.
1) Are there any problems with the circuit?
2) When the load of the DAC is OPAMP, what is the variation of the output rail?

According to the data sheet the output rail is limited to the load. However, I think that this circuit is almost no load.

Best regards,

hiroshi

over 5 years ago

0 Uttam Sahu over 5 years ago

TI__Genius 14220 points

Hi,

Thank you for your query. In order to debug this problem quickly, could you plese provide the following details:

1. Value of AVDD
2. The plot taken after isolating the load. I understand that the opamp should act as a no-load but let's make sure there is no other path
3. Observe the change in supply current with load and no-load conditions

Regards,
Uttam Sahu
Applications Engineer, Precision DACs

0 user5163865 over 5 years ago in reply to Uttam Sahu

Genius 3640 points

Hi Uttam

Thank you for your reply.

The AVDD is 5V.
I will check about 2. & 3. soon.

Best regards,
Hiroshi

0 Kevin Duke over 5 years ago in reply to user5163865

TI__Mastermind 46290 points

Hiroshi,

Do you have any update on this topic?

Was the DAC output voltage measured at the test point? Or, were you making measurements at the output of the OPA277?

0 user5163865 over 5 years ago in reply to Kevin Duke

Genius 3640 points

Hi, Kevin

I'm sorry for late.

After all, it was their measurement mistake.
It is working normally now.

Thank you for all the helpful advice you gave me.

Best regards,

Hiroshi

Data converters

Data converters forum

DAC7311: Output rail issue