Following the user manual, I have set up our TX517EVM. After power up,LED 3 and 7 are both off and I cannot get any results on the oscilloscope. I played with the 8 buttons on the board, but cannot managed to make it work.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Thanks for your reply.
The LED3 and LED7 are not turning on from the start. the 5V, 3.3V and 1.2V test point is OK, but the LED6 is off.
I just want to test the CW mode, so I apply +11V to the VCW, but not apply any voltage to the HV0,LV0,HV1,LV1 and HV2,LV2.
Finally, I press the CW mode button according to the manual , but there are not any output results. Also,there are not any sinal on the JP30 and JP31 for CWINA and CWINB.