Other Parts Discussed in Thread: ADS1261, ADS1235,
Hi everyone,
the firmware of this evaluation board recognizes plain-text commands such as "ID", "COMMAND LIST", "READSINGLE", etc., see Table 7 in "ADS1261 and ADS1235 Evaluation Module" (SBAU293A). These commands can be sent from the "Delta-Sigma ADC EvaluaTIon Software".
My question is: could I also send these commands to the board from my own software? When I plug the board into a Windows machine with the necessary TI drivers installed, I see a "Generic Bulk Device" in device manager, but not, e.g., a virtual COM port.
Any help would be greatly appreciated!
Best regards,
Christian