Hi team,
I wonder is this device able to read data for a certain channel at one time instead of reading all the 8 channels? And how?
Thank you very much!
George
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
I wonder is this device able to read data for a certain channel at one time instead of reading all the 8 channels? And how?
Thank you very much!
George
Hardware mode, Parallel interface.
Hi George,
If the data only for a certain channel is expected, why is an 8-ch ADC selected, can you please clarify?
Thanks®ards,
Dale
Hi Dale,
I'm just asking if it is able to do that.
So normally we have to read all the channels and then select the data we need?
Hi George,
The output data corresponds to the /RD signal, you can read data from a specific channel, however you have to send out certain /RD pulses to the ADC during one /CS read cycle, for example, read the data of 2nd channel by sending two /RD pulses, read the data of 3rd channel by sending three /RD pulses.
Another simple solution is, get rid of the data on the rest of channels after read the data on all eight channels.
Regards,
Dale