• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 47 subscribers
  • Views 214 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS5483: CLKP CLKM pullup/pulldown resistors connected to "ANALOG" VDD/GND?

Davide Badoni
Prodigy 200 points
Part Number: ADS5483

Dear Sir,
in the "Clock Inputs" section of the relevant datasheet, appears that the clock signals are referred to as analog GND and VDD (despite it seem to be digital signals), thus I have connected my pullup/pulldown resistors to analog VDD and GND as in the attached figure.
Is it the best choice?
Thank you very much
Davide Badoni

davide.badoni@roma2.infn.it

  • 0
    TI__Mastermind 28810 points

    Hi Davide,

    There is lot of older information out there that can be mis-leading, but in general for a high-speed converter, the sample clock is not a digital signal it is referred to analog.

    We recommend a single point ground for best performance, there is no need to split grounds.

    The figure you have above should be fine.

    Regards,

    Rob