TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DAC38RF82: DAC38RF82 PLL cannot get LOCK 0

    65 views
    1 reply
    Latest 8 days ago
    by Wenhui Guo
  • Answered

    DAC63204: DAC63204 I2C lockup 0

    72 views
    3 replies
    Latest 8 days ago
    by Brett Hansmeier
  • Not Answered

    TSW14J50EVM: TSW14J50EVM Consultation on Usage Issues 0

    32 views
    1 reply
    Latest 8 days ago
    by yingjiao LI
  • Not Answered

    ADS54J60: Missing test setup for ADS54J60. Unable to reproduce ENOB for 2nd Nyquist from datasheet. 0

    229 views
    7 replies
    Latest 8 days ago
    by Rob Reeder
  • Answered

    ADS124S08: OPA2626 used with ADC--IDAC: source or sink? 0

    58 views
    2 replies
    Latest 8 days ago
    by Randy Openshaw
  • Suggested Answer

    TMCS1123: Hall element material investigation request 0

    120 views
    4 replies
    Latest 8 days ago
    by Carolus Andrews
  • Not Answered

    AMC7908: AMC7904: Proposal for Controlled Output Sequencing Using AMC7904 in TDD Applications 0

    115 views
    8 replies
    Latest 8 days ago
    by Erin Bowrie
  • Answered

    ADS131M04: Transitioning between power modes 0

    53 views
    1 reply
    Latest 8 days ago
    by Joachim Wuerker
  • Suggested Answer

    ADC3910D125: DCLKIN vs DCLK and nDCLK/FCLK 0

    60 views
    1 reply
    Latest 8 days ago
    by Luke Allen
  • Not Answered

    BP-DAC11001EVM: Software cannot talk to eval board 0

    119 views
    4 replies
    Latest 8 days ago
    by Sanjay
  • Suggested Answer

    ADS4222EVM: Request for ADS4222EVM Schematic Source File (OrCAD or Equivalent) 0

    50 views
    1 reply
    Latest 8 days ago
    by Geoff Roth
  • Not Answered

    ADS1292: Incorrect voltage being outputted through RLD 0

    91 views
    3 replies
    Latest 9 days ago
    by Ryan Guzzwell
  • Suggested Answer

    ADS1299: ADS1299 VCAP1 charging time 0

    156 views
    2 replies
    Latest 9 days ago
    by Ryan Andrews
  • Suggested Answer

    ADS1298: SPI not reading 0

    324 views
    13 replies
    Latest 9 days ago
    by Ryan Andrews
  • Answered

    ADS1219: Wrong ADC Count 0

    89 views
    3 replies
    Latest 9 days ago
    by JAOverstreet
  • Answered

    ADS122C04EVM: Downloaded the ADS122C04EVM device package but can not open it 0

    82 views
    2 replies
    Latest 9 days ago
    by Raqiya .
  • Answered

    ADC12DL3200: Clocking and synchronization of ADC12DL3200 and DAC12DL3200 0

    147 views
    6 replies
    Latest 10 days ago
    by Mirza Pasovic
  • Suggested Answer

    FDC1004: FDC1004 Drift Over Time 0

    97 views
    5 replies
    Latest 11 days ago
    by Eddie LaCost
  • Not Answered

    DAC39RF10: Any ways to monitor INA devices on the EVM through the GUI? 0

    62 views
    1 reply
    Latest 11 days ago
    by Rob Reeder
  • Suggested Answer

    ADS9224R: Mistake in Datasheet? 0

    56 views
    1 reply
    Latest 11 days ago
    by Yolanda Gonzalez
<>