TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1248: ADS1248 0 Locked

    554 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    ADS1118: Error when reading ambient temperature & thermocouple simultaneously !! 0 Locked

    847 views
    2 replies
    Latest over 6 years ago
    by milad chalipa
  • Answered

    ADS8691: Passive Component Selection 0 Locked

    595 views
    3 replies
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    ADS8684 does not measure 0 Locked

    1884 views
    17 replies
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    DAC3482EVM: Phase noise out of DAC higher then DAC CLK Phase noise? 0 Locked

    2017 views
    7 replies
    Latest over 6 years ago
    by Kang Hsia
  • Suggested Answer

    ADS1256: ADS1256 strange problems --> DRDY remains high for longer time after issuing the SYNC command 0 Locked

    1996 views
    9 replies
    Latest over 6 years ago
    by Christopher Hall
  • Suggested Answer

    ADS1298: ADS1298 Lead off with AC coupling 0 Locked

    1330 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    RE: ADS131E08: Need C sample driver code 0 Locked

    344 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    TSW40RF82EVM: NCO noise dependence 0 Locked

    1196 views
    5 replies
    Latest over 6 years ago
    by Marcel Auboiroux
  • Not Answered

    ADS7828: Input impedance 0 Locked

    402 views
    1 reply
    Latest over 6 years ago
    by Abhijeet Godbole
  • Answered

    ADS1192: ads1192 and nRF52832 SPI communication by keil 0 Locked

    1276 views
    5 replies
    Latest over 6 years ago
    by Kaito
  • Answered

    AFE4900EVM: AFE4403 EVM GUI Windows 10 0 Locked

    1299 views
    4 replies
    Latest over 6 years ago
    by user5148774
  • Suggested Answer

    TSW14J56EVM: Problem with USB3 enumeration 0 Locked

    2079 views
    11 replies
    Latest over 6 years ago
    by Piotr Golabek
  • Answered

    ADS1242: ADS1242 for 4 single ended signal measurement 0 Locked

    732 views
    3 replies
    Latest over 6 years ago
    by Joachim Wuerker
  • Answered

    ADS1256: ADS1256 power down and restart 0 Locked

    537 views
    2 replies
    Latest over 6 years ago
    by Kailyn Chen
  • Suggested Answer

    ADS1225: output latched 0 Locked

    543 views
    5 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS112U04: ADS112U04EVAL MACHINE CODE 0 Locked

    939 views
    5 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS114S08: the resolution of ADC of 2.4 of sbaa275 configuration 0 Locked

    689 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    ADS1282EVM-PDK: What to do with the PINMOD pin? 0 Locked

    481 views
    1 reply
    Latest over 6 years ago
    by Christopher Hall
  • Suggested Answer

    RTOS/ADS5482: How to read the data in the DDR of TSW1400 using MATLAB directly 0 Locked

    685 views
    3 replies
    Latest over 6 years ago
    by dBrock
<>