• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 46 subscribers
  • Views 344 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS131E08EVM-PDK: Gerber files for ADS131E08EVM PDK

Girish Vaidya
Prodigy 70 points
Part Number: ADS131E08EVM-PDK
Other Parts Discussed in Thread: ADS131E08

Hi,

  I wanted to check if i can order only the daughter card (the board with ADC, not the MMB0 motherboard). I would need couple of ADCs for my setup, though a single motherboard might suffice.

Alternatively, can i get access to the gerber of the daughter card.

Regards,

Girish

  • +1
    TI__Guru 57336 points

    Hello Girish,

    Welcome to our forum and thank you for your post.

    We only sell our ADC daughterboards with the MMB0 motherboard as a kit, not individually.

    You can find the gerber files for the ADS131E08EVM below:

    6527354_ADS13xE08_gerb_a.zip

    Regards,

    Ryan

  • +1 in reply to Ryan Andrews
    Prodigy 70 points

    Thanks for the prompt response. I saw the gerber files (viewed using Viewmate gerber viewer). I didnt see a copper fill for power /ground in any of the layers. The pictures of the layers in the 'Performance demonstration kit for the ADS131E08 Users Guide' also dont show a copper fill for ground. Just wanted to be sure that the gerber files shared are up-to-date and could be taken for PCB fabrication.

    Regards,

    Girish  

  • 0 in reply to Girish Vaidya
    TI__Guru 57336 points

    Hi Girish,

    Internal Layer 1 is the ground plane. Internal Layer 2 is the power plane. These are the latest gerbers.

    Please note that it is ultimately your responsibility to ensure accuracy before manufacturing. 

    Regards,

    Ryan