• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Subscribers 53 subscribers
  • Views 6043 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CCS Update and now debug errors

Greg Loucks
Prodigy 165 points
Other Parts Discussed in Thread: AM1808

I did a CCS update yesterday and now I get the following error from the debugger:

ARM9_0: Error: (Error -242 @ 0x2A49) A router subpath could not be accessed. The board configuration file is probably incorrect. (Release 5.0.333.0)

What should I do? Can I roll back the update? How can I find out what was updated?

CCS Version: 4.2.3.00004

XDS100v2 USB Emulator

AM1808 Experimenter Kit

 

  • 0
    TI__Guru**** 450771 points
    Hi Greg, Unfortunately you cannot rollback an update. What version did you upgrade from (when everything was working fine)? ki
  • 0 in reply to Ki
    Prodigy 165 points
    The previous CCS version was 4.2.1.00004. Is there anyway to tell what the 'board configuration file' is?
  • 0 in reply to Greg Loucks
    Prodigy 165 points
    I'm also getting this message: ARM9_0: Warning: (Error -1029 @ 0x2B5F) Invalid data read from ICECrusher register. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Release 5.0.333.0) How do I 'lower TCLK'? I'm assuming this is relating to the USB100v2?
  • 0 in reply to Greg Loucks
    TI__Guru**** 450771 points
    Can you try creating a new target configuration from scratch (instead of using the one that you used before the update)? I was able to connect fine with 4.2.3 and the AM1808 but I created a new config.
  • 0 in reply to Ki
    Prodigy 165 points

    That was it. A new project works fine. I went back to the other projects and made sure they were using the new tool chain. Then no problem.

     

    Thanks!