AM335x eMMC programming through JTAG

Maynard Cabiente

Other Parts Discussed in Thread: AM3352, AM3874

Hi,

Is there a wiki site already that shows the steps on how to use JTAG (e.g. XDS560) and CCS to program eMMC on an AM3352 CPU?

There is a site already for programming NAND flash only. I'm not quite sure if it accomodates eMMC as well.

http://processors.wiki.ti.com/index.php/AM335x_Flashing_Tools_Guide

I know that there is a wiki for programming eMMC without CCS/JTAG but since we have a XDS JTAG already and CCS I was trying to just follow what we did on our AM3874 custom boards.

http://processors.wiki.ti.com/index.php/Sitara_Linux_AM335x_Flash_Programming_Linux_Development

Regards,
Maynard

over 11 years ago

0 Miroslav Kiradzhiyski XID over 11 years ago

TI__Mastermind 25235 points

Moving to CCS forum.

Best regards,
Miroslav

0 desouza over 11 years ago

TI__Guru**** 171104 points

Maynard,

Sorry, we at the CCS forum are not the most knowledgeable about the different flashing mechanisms of AM335x devices. There is a tool called Uniflash that supports Sitara processors, but the information on the page below does not mention eMMC:

http://processors.wiki.ti.com/index.php/Sitara_Uniflash_Quick_Start_Guide

From inside CCS, the only way I see this being possible is if an example project performs this task - I am unaware of such thing. The CCS/JTAG does not perform external flash programming of any kind, as the number of flash IC vendors and the possible combinations of interfaces (SPI, parallel, I²C, etc.) and the physical arrangement varies greatly from board to board.

Regards,

Rafael

Code Composer Studio™︎

Code Composer Studio forum

AM335x eMMC programming through JTAG