TINA/Spice/LP8863-Q1: Uncrypted Spice Model Request

Alessandro Nocentini

Part Number: LP8863-Q1
Other Parts Discussed in Thread: TINA-TI,

Tool/software: TINA-TI or Spice Models

I've seen that on TI website there is a PSpice Model for LP8863-Q1, but this model is crypted so this is my question, it's possible to have the uncrypted version of the model?

over 7 years ago

0 Herman Theodorus over 7 years ago

TI__Genius 9775 points

Hi Alessandro,

Unfortunately the unencrypted SPICE model for this device is not available for distribution. I apologize for any inconvenience. But if you are using TINA-TI, we can do raw import the file from the Pspice into TINA-TI and give you the encrypted TINA file. Let me know if you are using TINA-TI for this simulation.

Herman

0 Alessandro Nocentini over 7 years ago in reply to Herman Theodorus

Prodigy 30 points

Yes, I use also TINA-TI for simulations, so you can send me TINA-TI compatible model.

Thanks

0 Karthik Kulkarni over 7 years ago in reply to Alessandro Nocentini

TI__Intellectual 1090 points

Hi Alessandro,

I am working on exporting the model to TINA-TI. I need to verify whether the sim runs fine and since the sim time is a bit high, we will require some time to share it here. You can expect a response from me by tomorrow.

Regards,
Karthik

0 Alessandro Nocentini over 7 years ago in reply to Karthik Kulkarni

Prodigy 30 points

Thanks, waiting for a message from you.

0 Karthik Kulkarni over 7 years ago in reply to Alessandro Nocentini

TI__Intellectual 1090 points

Alessandro,

Excuse me for the delay. Please find attached the schematic file. It is configured for the Boost startup schematic. Please note that it is a beta model.

3201.LP8863-Q1_TRANS.TSC

Regards,

Karthik

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TINA/Spice/LP8863-Q1: Uncrypted Spice Model Request