DLPNIRNANOEVM: Board Cannot be Detected

Mark Philip Felipe

Part Number: DLPNIRNANOEVM
Other Parts Discussed in Thread: DLPC150

Hi Team, seeking for some assistance to troubleshoot.

Board cannot be detected, This occurs after I update one wrong firmware. I have tried use boot loader mode but I am not sure if my device is on the boot loader mode correctly.

Thank you.

-Mark

over 1 year ago

0 Vivek Thakur over 1 year ago

TI__Mastermind 22830 points

Hello Mark,

Could you please confirm that EVM is not detected by the GUI i.e. "Connected" radio button is not green?

Could you please also share what firmware part did you upgrade with wrong binary i.e. TIVA, DLPC150?

regards,

Vivek

0 Akhil Guntumadugu over 1 year ago in reply to Vivek Thakur

TI__Expert 3425 points

Hello Mark,

Please refer to the user guide: https://www.ti.com/lit/ug/dlpu030g/dlpu030g.pdf?ts=1656319195651&ref_url=https%253A%252F%252Fwww.ti.com%252Ftool%252FDLPNIRNANOEVM

Section K.3: System Not Responding - NIRscan Nano Updated with Untested/Faulty Tiva Firmware

Regards,

Akhil

DLP®︎ products

DLP products forum

DLPNIRNANOEVM: Board Cannot be Detected