• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 265 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DLP2010NIR: Factory reference scan

Jonathan Navor
Genius 9475 points
Part Number: DLP2010NIR

Hi Team,

Good day! Kindly please help us with our customer's issue below.

We would like to know if is it possible to have the factory reference scan. We have a DLP NIRscan Nano (DLP2010NIR). It came with a reference data stored.
Models were constructed with spectra acquired using this data as reference (Factory option at the NIRscan Nano GUI software).

Recently, a user from work have replaced the stored reference data by a spectrum from spectralon reflective material (Replace Reference Calibration section at NIRscan Nano GUI ).

The problem is that the previous constructed models are not working properly with the spectra aquired using this new reference data. So, we would like to know if it is possible to recover that reference data that was previously stored in the equipment (which came from factory)?

Thank you in advance for the support. 

Best regards,

Jonathan

  • 0
    TI__Genius 12785 points

    Hi Jonathan,

    Welcome to the E2E forum and thank you for your interest in DLP® technology!

    Please allow us until next week to get back to you with a response.

    Regards,

    Austin

  • +1
    TI__Expert 3735 points

    Hello Jonathan,

    The factory reference scan is always present in EEPROM and is selected using "Factory" option. Whenever a new reference is created using "New" option from GUI, it just stores the reference data locally in PC. Hence you can always revert back to factory reference by selecting the "Factory" option.

    FYI: You can always verify the reference by comparing the csv scan data and know which reference is selected for that particular scan.

    Regards,

    Akhil