We are NOT going to use Motor Driver. How should I connect AOUT1/2 and BOUT1/2 in than case?
In the Datasheet I have found info only about VINM:
VINM can be left floating if the motor controller is not used
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
We are NOT going to use Motor Driver. How should I connect AOUT1/2 and BOUT1/2 in than case?
In the Datasheet I have found info only about VINM:
VINM can be left floating if the motor controller is not used
Hello User,
Welcome to the E2E forum and thank you for your interest in DLP® technology!
If you are not planning on using AOU1/2 and BOUT1/2 you can simply leave these pins open.
Regards,
Austin