• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 208 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DLP4710EVM-LC: Display problem with error picture

WD Xue
Prodigy 10 points
Part Number: DLP4710EVM-LC

Dear,

I brought a set of DLP4710EVM-LC device from Mouser (mouser.cn) on March 23rd, but a device problem happened within a month. When the device was powered on,  the display screen is error, the left half cannot display picture, with white or black, but the right half can display correct picture. I have contacted the TI supporter of China, they let me flash the firmware.  After do this, the problem temporarily disappeared, but server days later, it happened again and again. Tomorrow,  I found when this problem is happening, I just switched the power and then power it again, it may solve this problem temporarily sometimes. So I think this may cause by the hardware, but not the software. I have contact the sale of Mouser, they let me contact the supplier offers by the E2E forum firstly to make sure if it is the hardware problem.

Thanks.

Best wisher!

The error display picture:

display problem

When I disconnect the power and reconnect power again, sometimes it can display correct.

Click here to play this video

The problem happen fist time:

 

  • 0
    TI__Expert 7910 points

    Hello user,

    Welcome to the E2E forum!

    When you re-flash the firmware on the EVM, can you confirm if both master and slaver controllers are programmed properly? If both controllers are programmed properly and you mentioned that the issued could be recovered after power cycle, then I suspect it could be the hardware issue. You should contact Mouser for further customer service about returning/replacing process. This statement serves as approval for RMA granted the device meets the warranty criteria. 

    Regards,

    Lori 

  • 0
    Prodigy 10 points

    I am sure when I re-flash the firmware both the master and slaver controller are programmed sucessfully. This problem happened sometimes,   These days, it somewhile happened when the EVM was power off after a few hours.

  • +1 in reply to WD Xue
    TI__Genius 12595 points

    Hello User,

    In such a case, it is advisable to have the EVM replaced. Please feel free to use this comment as approval for RMA granted that the device is still under warranty.

    Regards,

    Austin