DLP4710: Illumination power and Wavelength Requirement

IKA OKTAVIA SURYANI

Part Number: DLP4710

Tool/software:

Hi,

I am using DLP4710 and laser with wavelength of 405nm. According to the datasheet, the maximum illumination power should be less than 10mW/cm^2. Is it possible to use higher power?

For example, I want to use to pulsed laser with peak power =1.03366 x 10^5 W/m^2, pulse ON = 2us, pulse OFF = 8us.

Thank you!

11 months ago

0 John McKnight 11 months ago

TI__Expert 7035 points

Hello User,

Please allow the team time to look into your question and get back to you.

Thank you,

John

0 IKA OKTAVIA SURYANI 11 months ago in reply to John McKnight

Prodigy 10 points

Hi,

Yes, sure. Thank you!

0 John McKnight 11 months ago in reply to IKA OKTAVIA SURYANI

TI__Expert 7035 points

Hello User,

TI has no data on this use case. There is no certain input TI can provide for you on this matter. The team would recommend that you are mindful of heat dissipation requirements for the DMD. You would also be responsible to figure out if the duration of the laser on time does not damage the DMD.

Best,

John

DLP®︎ products

DLP products forum

DLP4710: Illumination power and Wavelength Requirement