This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DLPLCRC410EVM: starting operation problem

Part Number: DLPLCRC410EVM
Other Parts Discussed in Thread: DLPLCR65NEVM, , DLPC900, DLPR410, DLPC410

Hi Team,

I have some questions with DLPLCRC410EVM Controller Board (we bought DLPLCRC410EVM + DLPLCR65NEVM). I follow the steps of Hardware Overview and Setup in DLP Discovery 4100 Development Kit Software User’s Guide (Rev. A) to start board operation. However, there is a problem on step 4--D2(red) and D3(green) keep illuminating and seem not turn off until I wipe SW4 down. I know that D2 and D3 illuminate means APPSFPGA configured work is not done, but it seems it take too much time on configuration(Not briefly illuminate).

The another question is related to above. I find that DLPLCRC410EVM end of the wire connecting DLPLCRC410EVM and DLPLCR65NEVM lost one pin(the picture in appendix). I want to ask whether this is normal and will this effect the operation of board operation?

Thanks in advance.

Regards,

haoyu