This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DLP5530-Q1: DLP5530 datasheet information confirm

Part Number: DLP5530-Q1

Hi Team

Good day!

Our customer want to confirm the details about datasheet 6.9 System Mounting Interface Loads.

Condition 1: Maximum load evenly distributed within each area(1)

Condition 2: Maximum load evenly distributed within each area(1)

What is the meaning of Condition 1 and Condition 2. I means what is the difference between condition 1 and 2 , the pressure spec is different means the condition 1 and 2 may have some differences , But the data sheet does not provide the details.

Best regards


  • Hello,

    The two conditions detail the maximum force/load that can be applied to each of the areas indicated by figure 12 below the table.

    Because the DLP5530-Q1 is a socketed device with a heatsink, pressure can be applied to either the electrical interface area where the DMD contacts the socket, or the thermal interface area where the DMD contacts the heatsink.  There are different amounts of maximum force that can be applied if you are applying the force to the whole DMD or just one area.  Condition 1 in the table lists the maximum force if applying force to the whole DMD, and condition 2 is if force is applied to only the electrical area, often when inserting the DMD in the socket.

    Best Regards,