DLPA2000: Fast Park conditions

Wladimir De la Cadena

Part Number: DLPA2000
Other Parts Discussed in Thread: DLPC3433

Hello, I have a custom board with the DLPA2000 and the DLPC3433. I made an initial test setting PROJ_ON high and it worked fine. I could see the splash image in the display. However, after some hours I reconnected my setup and no light came to the display. I debugged and found the fast park condition. Reset is going low around 40 uS after ParkZ goes from high to low. So nothing starts now. The setting has not change, and I would like to find out what is causing the park condition. The datasheet suggests some power failure, but so far all power rails are there and at good values. Any suggestion?

over 3 years ago

0 Philippe Dollo over 3 years ago

TI__Mastermind 28005 points

Wladimir,

When you say "after some hours" do you mean to say that you set power off, left the system, and find the system to no longer power on later?

If so, did you manipulate the system in any manner between first and second operation? Aside from power rails, are other startup signals coming up OK? You can check them against the power up timing diagram on the DLPC3433 datasheet.

Failing that, do you have a schematic you can share of your design?

Regards,

Philippe

0 Wladimir De la Cadena over 3 years ago in reply to Philippe Dollo

Prodigy 220 points

After I saw the splash image, I powered down and disconnected the power supply. Then, when I powered up again it did not work. Yes, I can check the power up timing, and that's why I identify a fast park. The reset comes high for around 30 ms. and then it goes low. IntZ from the DLPA goes up and around 40uS after reset goes low, INTZ goes low too. Thus, I concluded the fast park. I wanted to know what exactly could trigger that in order to check it with more detail

+1 Philippe Dollo over 3 years ago in reply to Wladimir De la Cadena

TI__Mastermind 28005 points

Wladimir,

Thanks for elaborating. Given the circumstances it does seem more likely than not to either be a connection issue with your hardware, or a problem with your schematic. If possible, can you share your schematic so that the team can review it?

Regards,
Philippe

0 Wladimir De la Cadena over 3 years ago in reply to Philippe Dollo

Prodigy 220 points

I accidentally marked the final answer as solution, and I cannot write more in the feed. Can I send the schematic directly to you, I would like to avoid to post it publicly

0 Austin Snyder over 3 years ago in reply to Wladimir De la Cadena

TI__Genius 12785 points

Hi Wladimir,

I will be following up with a friend request so that the schematic can be shared privately.

Regards,

Austin

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

DLP®︎ products

DLP products forum

DLPA2000: Fast Park conditions