Interfacing DLPC3430 with microcontroller TM4C129LNCZAD ?

Vishal Gaurav

Other Parts Discussed in Thread: TM4C129LNCZAD, DLPC3430

I am writing firmware for TM4C129LNCZAD I want to know how DLPC will receive data/instructions from micro controller (some initialization sequence). what are the steps that need to be followed

Best Regards

over 8 years ago

0 Trevor Dowd over 8 years ago

TI__Expert 6370 points

Hi Vishal,

I am going to move your question into a forum where we discuss DLPC3430 topics. Someone should be able to address your question there.

Best regards,
Trevor

0 Nadine Estermann over 8 years ago in reply to Trevor Dowd

TI__Genius 10475 points

Hello Vishal,

The MSP430 is communicating to the DLPC3430 via I2C. The I2C commands can be found in our Software Programmers Guide.

There is no start up sequence since the DLPC3430 firmware is stored in the flash device.

After initialization is completed the MSP430 can start sending commands via I2C to the DLPC3430.

Best regards,

Nadine

DLP®︎ products

DLP products forum

Interfacing DLPC3430 with microcontroller TM4C129LNCZAD ?