Other Parts Discussed in Thread: DLPC350
Dear All,
My customer will start to develop 3D measurement projector it based on TI LightCradter4500 reference design.
They won't use both DLPC350 port1(parallel) and port2(FPD-LINK) input in their design , therefore they will remove any parts around the ports.
In that case , is it OK leaving open all the unused pins of the both ports?
One more question, is there any possibility that this customer would face any problem(GUI crash or something) when they set operate mode to Video mode (or pattern sequence mode with video port) by TI GUI?
Any your advice would be appreciated.
Thank you and best regards,
Rossinag